3D printer main control board MKS Gen V1.2

Features:

1) The 2560 and ramps1.4 set on a board, to solve complicated Ramps1.4 combination of interfaces, the problem of failure prone.

2) Replace the motor drive, supports 4988 and 8825 drivers drive.

3) The board uses a high quality 4-layer, heat and made a special optimization; ramps are 2 shelves.

4) MOSFET, high quality, better heat dissipation.

5) the use of a dedicated power supply chip, support 12V-24V power input, solve the heating problem Ramps voltage converter chip.

6) can accept 24V input power under the same system can be hot-bed current is reduced to 1/4, an effective solution to the hot bed MOS pipe heat problems.

7) The firmware can use open source firmware Marlin, ramps1.4 identical configuration and can directly replace Ramps1.4.

8) can be directly connected to the control panel and 12864LCD Ramps1.4,2004LCD control panel.

9) reserved for motor pulse and direction output ports for easy plug-in high-current To add a large current (eg 2A, 5A) motor drive circuit.

10) retention Ramps1.4 on Servos, AUX-1, AUX-2 interface that provides three 5V output, three 12V outputs.